Wheel Gear 2, Main Cam And Mode Switch - Sony SLV-E105 Service Manual

3-15. WHEEL GEAR 2, MAIN CAM AND
2)
3)
4)
5)
6)
MODE SWITCH
(See Figs.3-15-1 and 3-15-2)
Refer to section 3-2 and remove the mechanism unit.
When you do this, make sure the mechanism is in
EJECT mode.
Refer to section 3-7-1, then remove the harness
mounting.
Remove the clamp), then remove the wheel gear 2@).
Remove the washer @, then remove the main cam@.
After unscrewing the screw @), remove the soldering
from the terminal of the mode switch ©.
Remove the clamp@, then remove the mode
switch ©.
ASSEMBLY NOTES:
1.
Apply grease SGL-505 to the shafts © and @ and @,
to the teeth of the main cam@), and to the all over the
cam groove of main cam@.
When fitting the mode switch ©, align it in @@® order
as shown in Fig.3-15-2. The alignment of the part ®
is shown in Fig. A. Position the teeth of the
mode switch © so that the sixth tooth space left of
part @is aligned with the triangular mark on the
pinch cam gear @). After aligning part ®, refer to
section 3-9-2 and check the positioning of the mode
switch, the pinch cam gear and the pinch lift cam.
Beforehand, remove the soldering from the soldered
part of the MC-1 PWB assembly, in order to prevent
the mode switch © being warped. Solder the mode
switch © after tightening the screw © (See Fig.
3-15-1).
Align the hole in the crescent slide @ with the hole in
the mechanism chassis, as shown at point @ in Fig.3-
15-2 (refer to section 3-16 and see the holes® and© in
Fig.3-16-1).
When fitting the main cam@, position the mode
switch © and the front rack gear @ as shown at points
© and © respectively in Fig.3-15-2.
When fitting the gear wheel 2(@), position the main
cam @ and the wheel gear 1(4 as shown at points
© and © respectively in Fig.3-15-2.
5-22
@><— @Washer
wa
Tr, @Clamp
F
@Wheel
gear 2 \ BS
ES
@Front rack
gear
@Crescent slide
Fig.3-15-1
@Pinch
cam
gear
Marks on mode
switch ©
@Front
rack
gear
Tooth tip on
main cam @
@Main cam
@Crescent
slide
6 my
oO WD oho
(Wheel gear 1
Fig.3-15-2