Start Rack Gear And Front Rack Gear-S:***T+1 - Sony SLV-E105 Service Manual

3-3-4. START RACK GEAR AND FRONT RACK GEAR
(See Figs.3-3-5 and 3-3-6)
1) Remove the mechanism unit, referring to section 3-2.
2) Remove the cassette mechanism assembly, referring
to section 3-3-1.
3) Remove the special screw @). When you do this, slide
the front rack gear assembly @ towards the front until
it stops, then take it off the shaft@. Take care not to
damage the shaft @.
4) Remove the spring @.
5) Remove the clamp © on the front rack gear ©), then
remove the start rack gear @.
ASSEMBLY NOTES:
1. Apply grease SGL-505 to the front rack gear © and
all over the inside of the groove on the start rack
gear @).
2. Align the positioning mark® on the front rack gear ©)
with the mark @ on the main cam @).
3. When installing the cassette mechanism assembly,
refer to section 3-3-1 and align the start rack gear with
eee @®Front rack gear
(apply grease to
-~ @_ inside of groove)
Shaft
@ Front rack
.. gear assembly
@Special screw
@Start rack gear
(apply grease to
inside of groove)
Fig.3-3-5
@®Positioning mark
@®Front rack
gear
Fig.3-3-6
3-4. CLEANER ROLLER ASSEMBLY
(See Fig.3-4-1)
1) Remove the clamp@ and take out the cleaner lever®.
When you do this, be careful not to bend the plastic
springs @ and ®on the cleaner lever @.
2) Remove the clamp ©, and take out the cleaner roller
assembly @). Be careful not to touch the sponge on the
cleaner roller assembly @).
ASSEMBLY NOTES:
1. When mounting the cleaner lever @ on the shaft ©,
press the clamp in the direction shown by the
arrow, and snap it into the mounting © on the audio
R/P head assembly.
<«— @Cleaner roller assembly
«— @Clamp
_— @Cleaner lever
«— @Clamp
®pPlastic spring —> —_
@Plastic spring
Fig.3-4-1