Page 1
WE-EF LEUCHTEN Installation and Maintenance Instructions Wall Luminaire Surface Mounted and Street and Area Lighting Luminaire FLA441 LED FLA461 LED Do not open during installation Surge Protection This product is factory-sealed. This product features built-in surge protection circuitry in compliance Refer to the instructions contained in this with applicable standards.
Page 2
Wall Luminaire Surface Mounted and Street and Area Lighting Luminaire FLA441 ø 11 FLA461 ø 11...
Light Source Maintenance Apart from cleaning the product’s exterior surfaces, no special maintenance work is required. Do not use high-pressure cleaners. In case of component failure due to abnormal circumstances or at end of life, replacement must be carried Warning: Do not open luminaire while mains supply is switched on.
(L = Phase, N = Neutral, = Earthing) b) WE-EF Control Basic (L = Phase, N = Neutral, Attention: The housing H containing the LED light = Earthing, Ls = Switching Phase) source is factory-sealed and does not need to be or WE-EF Control Dynamic opened during installation.
Installation Instruction 1) Note: It is the responsibility to installer to 2) Please note, ESV4 and ESV6 must be ensure the suitability of the ESV/ESZ planted root for any local or national structural require- In both instances conduit entry can be rotated ments for installation, and that planted root is to match cable routing.
Page 12
5) For ESZ4 please orientate planted root as shown (base plate is parallel to the pathway). cal connections/conduit. For this installation, use 30 mm long M12 bolts for PSY planted root and 35 mm long M10 bolts for MRY planted root. M12 x 30 M10 x 35 7) Place the ESV/ESZ in the form work for con-...
Page 13
9) Pour concrete to desired level depending on requirement of concrete, paver or soil. Ensure (as per luminaire instructions) onto mounting level. Concrete Paver Soil...