Angelo Decor AD95513W Quick Start Manual

Lampada Fountain
We hope you will find these instructions helpful in setting up your product. If you have any issues with this item, DO NOT
return the unit to place of purchase. Please visit our web site www.angelodecor.com for assistance and warranty
information.
Carefully unpack and arrange
all parts.
Attach the tubing from the
top plate to the fiting from
the pump.
If desired, water flow can be
adjusted using the control
dial on the front of the pump.
Fill with clean water and plug into a grounded GFCI outlet.
The pump must be fully submersed at all times to avoid pump burnout.
This product must be dried and stored during freezing temperatures.
The pump comes pre-
installed in the reservoir with
the cord pipe installed.
Position the fountain in the
desired location and retrieve
the power cord from the
base.
Add water to the reservoir
until the waterline reaches
just below the cord pipe.
Position the top plate over the fountain.
Locate the pre-installed light cables and securely attach
them to the corresponding connections from the pump.
Check all connections then
align and lower the top plate
on to the reservoir.
AD95513W
Printed in China