Bristol Fountain
We hope you will find these instructions helpful in setting up your product. If you have any issues with this item, DO
NOT return the unit to place of purchase. Please visit our web site www.angelodecor.com for assistance and
warranty information.
Carefully unpack and arrange all parts.
Install the cord pipe cover over
the pipe and cords. This
accessory helps eliminate the
potential for water loss during
operation.
Retrieve any excess cord from
the pump and light at the base of
the unit. Align those cords with
the groove at the base.
Fill with clean water and plug into a grounded GFCI outlet.
The pump must be fully submersed at all times to avoid pump burnout.
This product must be dried and stored during freezing temperatures.
Pass the cord from the pump
down the cord pipe and retrieve it
at the base.
Locate the tubing and attach it to
the pump.
Water flow can be adjusted using
the dial located on the front of the
pump.
Attach the cable from the light to
the transformer.
AD95160
Pass the light cable down the
cord pipe and retrieve it at the
base.
Place the pump inside of the
fountain. Lower the plate on to
the fountain reservoir and ensure
the light is installed flush with the
plate.
Printed in China
Need help?
Do you have a question about the Bristol AD95160 and is the answer not in the manual?
Questions and answers