Angelo Decor Veneto AD93707 Quick Start Manual

Veneto™ Fountain
We hope you will find these instructions helpful in setting up your product.
If you have any issues with this item, DO NOT return the unit to place of purchase.
Please visit our web site www.angelodecor.com for assistance and warranty information.
Arrange all parts in your
workspace.
Install the cord pipe
cover over the cord pipe
as shown.
Connect the tubing to the pump then place
the pump inside the housing. Install the
pump access door.
Fill with clean water and plug into a grounded GFCI outlet.
The pump must be fully submersed at all times to avoid pump burnout.
This product must be dried and stored during freezing temperatures.
Carefully rest the large
bowl on its side. Pass the
power cord from the
pump down the cord
pipe.
Set the pump
housing / riser in to
place, align the
grooves then twist
and lock it to the
bowl.
Pass the pump cord
down the pedestal and
out the base. Align the
pump cord with the
groove at the base of the
pedestal.
Align, lower and
lock the small bowl
to the riser.
The
included
'shims' can
be used to
level the
fountain if
needed.
AD93707
Carefully lower the
bowl on to the
pedestal. Align the
grooves, then twist
and lock the large
bowl to the pedestal.
Connect the tubing to
the top then pass it
down the centre of the
small bowl. Lower the
top in place.
Printed in China
Installer