Angelo Decor Montgomery Instructions

Montgomery Fountain
We hope you will find these instructions helpful in setting up your product. If you have any issues with this item, DO
NOT return the unit to place of purchase. Please visit our web site www.angelodecor.com for assistance and
warranty information.
Carefully unpack and arrange all parts.
Attach the tubing to the pre-installed
light fixture as shown above.
Fill with clean water and plug into a grounded GFCI outlet.
The pump must be fully submersed at all times to avoid pump burnout.
This product must be dried and stored during freezing temperatures.
Place the pump inside the reservoir
then pass the power cord down the
cord pipe.
Check to ensure the pre-installed light
is properly set in place to prevent any
internal dripping.
Attach the tubing to the pump.
Lower the top piece on to the body
of the fountain.
AD95111
Install the cord pipe cover over the
cord pipe to prevent any chance for
water-loss.
Locate the light cable and securely
attach it to the corresponding cable
from the pump.
Printed in China