Angelo Decor Emelia Assembly Instructions

Emelia Fountain
Two People, following these instructions will make your assembly experience Easy!
Additionally, a video of this item assembled and running is available on our web site.
If you have any issues with this item, Please DO NOT return the unit to place of purchase.
Please visit our web site www.angelodecor.com for assistance and warranty information.

Carefully unpack all parts.

Rinse non-electrical parts
with clean water.
Pass the cord from the connector and the pump cord
down the pedestal and out the base. Align the cords
with the groove in the base of the pedestal. Securely
attach the cord from the light to the transformer.

Fill with clean water and plug into a grounded GFCI outlet.

The pump must be fully submersed at all times to avoid pump burnout.
This product must be dried and stored during freezing temperatures.
Hold the top close and pass pump and light cords down the cord pipe. Leave
about 4 inches of slack for each. With all cords through the bowl, securely attach
them to the "3 to 1 connector". A tight seal will ensure proper light operation!
Check the lights to
ensure they are secured
properly.
We recommend testing
the operation of the
lights before adding
water.
With the help of another person, carefully lift the bowl
and top over the pedestal. Align the bowl to the
pedestal. Check for obstructions then lower in place.
Turn clockwise to lock.
Attach the pump to the tubing.
The light cords should all have a
"drip loop". Install cord pipe cap.
Align and lower the top on to the
bowl.
AD91017
Our Thanks
Again!
Déballez
toutes le
les partie
Faites pa
pompe s
fils avec
solideme
Printed in China