Angelo Decor AD97023 Quick Start Manual

Clearwater Fountain
We hope you will find these instructions helpful in setting up your product.
If you have any issues with this item, DO NOT return the unit to place of purchase.
Please visit our web site www.angelodecor.com for assistance and warranty information.
Arrange all the parts in Arrange all the parts in
your work area. your work area.
The tubing should pass in to the hole shown above The tubing should pass in to the hole shown above
left and then in to the reservoir area as shown above left and then in to the reservoir area as shown above
right. right.
Place the decorative
pump cover over the
pump.
Place the bird on the fountain
as shown.
Fill with clean water and plug into a grounded GFCI outlet.
The pump must be fully submersed at all times to avoid pump burnout.
Product must be properly stored for winter.
Pass the power cord down Pass the power cord down
the hole (shown above) the hole (shown above)
and out the base.
and out the base.
Place the pump inside the
reservoir as shown.
The final assembly should look
like this
Align the cord with the Align the cord with the
groove at the base. groove at the base.
Connect the pump to the Connect the pump to the
tubing. tubing.
Hang the bucket from the
hook.
AD97023
Align and install the top Align and install the top
on to the fountain. on to the fountain.
Adjust the flow control as Adjust the flow control as
needed. needed.
The included rope can
wrapped around the bucket
handle and top for a
personalized appearance.