Installing And Removing Power Supplies; Installing A Power Supply - HPE Networking Comware 5960 Switch Series Installation Manual

Figure2-16 Removing a fan tray

Installing and removing power supplies

WARNING!
• To avoid bodily injury or device damage, strictly follow the procedures in
Figure2-18
• Provide a separate circuit breaker for each power supply.
CAUTION:
Make sure each slot has a filler panel or module installed when the switch is operating.
The switch came with power supply slot PSU1 empty and power supply slot PSU2 installed with a
filler panel.
The HPE NW CW 5960 400G 1600W AC PSU (R9Y18A) is available for the switch. For the power
supply specifications, see HPE 5960 Switch Series Hardware Information and Specifications.
Figure2-17 Power supply installation procedure
Install the power
supply
Figure2-18 Power supply removal procedure
Turn off the circuit
breaker

Installing a power supply

1. Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Remove the filler panel, if any, from the target power supply slot, as shown in Figure2-19.
to install and remove a power supply.
Connect the power
Disconnect the power
cord
cord
16
Figure2-17
Turn on the circuit
breaker
Remove the power
supply
and