Table of Contents
Advertisement
Figure2-6 1U short slide rails and chassis rails
Mounting brackets, chassis rails, and grounding cable
installation positions
The switch provides two grounding points: primary grounding point (with a grounding sign) and
auxiliary grounding point, as shown in Figure2-7.
Select installation positions for the mounting brackets, chassis rails, and grounding cable as
required.
Figure2-7 Mounting brackets and grounding cable installation positions on the switch
(1) Power supply-side installation position for the mounting bracket
(2) Primary grounding point
(4) Port-side installation position for the mounting bracket
Attaching mounting brackets and chassis rails to the switch
IMPORTANT:
M4 screws are used to attach mounting brackets and chassis rails to the switch. As a best practice,
use a torque of 12 kgf-cm (1.18 Nm) to fasten M4 screws.
To attach the mounting brackets and chassis rails to the chassis:
1.
Place the wide flange of the mounting bracket against the chassis side panel. Align the
mounting bracket installation holes with the screw holes in the side panel. Then use the
provided M4 screws to attach the mounting bracket to the chassis.
To install the mounting brackets at the port-side mounting position, see Figure2-8.
To install the mounting brackets at the power supply-side mounting position, see Figure2-9.
Use the four installation holes at the narrow side of the mounting brackets for installation.
(3) Auxiliary grounding point
8
Advertisement
Table of Contents
