Table of Contents
Advertisement
Electromagnetic wave radiation.
•
Common impedance (including the grounding system) coupling.
•
To prevent EMI, use the following guidelines:
If AC power is used, use a single-phase three-wire power receptacle with protection earth (PE)
•
to filter interference from the power grid.
Keep the switch far away from radio transmitting stations, radar stations, and high-frequency
•
devices.
Use electromagnetic shielding, for example, shielded interface cables, when necessary.
•
To prevent signal ports from getting damaged by overvoltage or overcurrent caused by lightning
•
strikes, route interface cables only indoors.
Laser safety
WARNING!
Disconnected optical fibers or transceiver modules might emit invisible laser light. Do not stare into
beams or view directly with optical instruments when the switch is operating.
The switch is a Class 1M laser device.
Installation tools
No installation tools are provided with the switch. Prepare the following tools yourself:
•
Phillips screwdriver.
ESD wrist strap.
•
Marker.
•
Installation accessories
Before installation, make sure you have all the required installation accessories. If an accessory is
damaged or lost, use its part No. to purchase a new one. You can find the part No. for the
accessories in Table1-3.
Table1-3 Installation accessories
Part No.
5190-0719
5185-8681
N/A
Description
Mounting brackets
1U rack-mount rail kit (short slide
rails)
M6 screw and cage nut
3
Applicable switch
Quantity
models
HPE NW CW 5960
1 kit, provided
24x100G/200G+8x40
0GQDD Sw
HPE NW CW 5960
Provided
24x100G/200G+8x40
0GQDD Sw
HPE NW CW 5960
User supplied
24x100G/200G+8x40
0GQDD Sw
Advertisement
Table of Contents
Need help?
Do you have a question about the Networking Comware 5960 Switch Series and is the answer not in the manual?