Table of Contents
Advertisement
The image above is an example, the appearance of your HIC may differ.
7. Place the HIC on a flat, static-free surface.
7.2.4. Step 4: Upgrade the HIC
After removing the old HIC, you install the new one.
Possible loss of data access — Never install a HIC in a DE6400 or DE6600
controller canister if that HIC was designed for another DE-Series controller. In
addition, both controllers and both HICs must be identical. The presence of
incompatible or mismatched HICs causes the controllers to lock down when you
apply power.
Steps
1. Unpack the new HIC and the new HIC faceplate.
2. Align the single thumbscrew on the HIC with the corresponding holes on the controller, and
align the connector on the bottom of the HIC with the HIC interface connector on the controller
card.
Be careful not to scratch or bump the components on the bottom of the HIC or on the top of
the controller card.
The image above is an example, the appearance of your HIC may differ.
3. Carefully lower the HIC into place, and seat the HIC connector by pressing gently on the HIC.
63
Advertisement
Table of Contents
