Q U I C K O P E R At I O N; Tu R N O N / O F F T H E S C A L E; Z E R O I N G - Elicom Electronic S300F Series User Manual

3 . 6 C o n n e c t i o n s
3 . 6 . 1 R S 2 3 2 i n t e r f a c e p o r t
3 . 6 . 2 S c a l e t o P C i n t e r f a c e c a b l e
Interface cables:
P/N Model Description
12-048 820 Direct connection Scale - PC
812 Split cable for 2 interfaces interface 1 – PC, Interface 2 – Printer
71-017 803 Used with 812 to connect to PC
Scale Connector
RJ11 6P4C
Fig. 3.11– Scale to PC cable connectors

4 . Q U I C K O P E R AT I O N

Tu r n O N / O F F t h e s c a l e

4 . 1
Press to power on the instrument. Scale activates the display for a few seconds then scale version is displayed. After
starting up cycle, weight value is displayed.
--0-- ERR
)
( prompt at power on announces zeroing range at the power on is exceeded or scale was not unloaded at power on.
The scale should be unloaded before power on.
Place the object you desire to weight over the scale. Weight of the object is displayed on the display.
To turn off the scale hold

Z e r o i n g

4 . 2
Zeroing is done to compensate deviations from zero of the unloaded pan.
1. Clean the unloaded platform and check if there is anything touching the platform.
2. Press key to compensate zero deviation. Zeroing is done if the scale is stable and in zeroing range.
3. Symbol appears to indicate that zeroing is done, and the scale is at center of zero.
Note that the maximum allowed deviation to be compensated by zeroing is +/- 2 % of the maximum scale capacity
Fig. 3.10 – RS232 port
PC Connector
DB9 Female
key for 3 sec.
Signal SCALE PC
Male Female
RJ11 6C4P DB9
TXD 5 2
RXD 4 3
GND 3 5
11