Detergent Pump - Smeg CWG410D Manual

6.1.6 Regeneration frequency setup (models with softener)
•
Default value: H00; modify the parameter to suit the mains water hardness.
•
Generally H03 will be satisfactory for most users.
•
At first use, the salt tank has to be filled. It is subsequently sufficient simply to fill up with regenerating salt
when necessary.
Regeneration cycle duration: 12 minutes
With values over 60°dF an external water treatment device must be used and the regeneration frequency must be
set on H00.
6.1.7 tStP (minimum rinsing temperature) function
Set at "on" for minimum rinsing temperature as set.
Set as "off" to accept minimum rinsing temperature a few degrees lower than the setting if hot intake water is not
used.
6.1.8 Rinse aid pump
Display (also reset when needed)

6.1.9 Detergent pump

Display (also reset when needed)
6.1.10 Energy consumption – Display and reset
Hardness
(°dH german
Modify the value
of the parameter
Regeneration off
by pressing .
Modify the parameter (ON/OFF) by pressing
To reset, press
To reset, press
To reset, press
12
Hardness
(°dF French
degrees) degrees)
Regeneration off
8,5
11
17
22,5
28
33,5
for 3 seconds.
for 3 seconds.
for 3 seconds.
Setting level
H00
15 H01
20 H02
30 H03
40 H04
50 H05
60 H06
.