Instructions For The User - Smeg CWG410D Manual

Boiler temperature probe malfunction
Err24
Boiler water filling malfunction
Err25
Boiler emptying malfunction
Err26
Boiler emptying malfunction – with tank full
Err27
Boiler heating malfunction (overheating)
Err28
8.1 Control panel
On-off button
Program selection button
Start CONFIRM/PAUSE button
Total emptying button (tank and boiler)
Additional function selection button
L1 Main power on light
L2 Intake/standby cycle in progress light (orange/green)
L3 Pump-out in progress light
No rinse-aid symbol (if a system for monitoring outside the dishwasher is provided)
Tank heating element on symbol
No salt symbol (if softener is fitted)
Boiler element on symbol
No detergent symbol (if a system for monitoring outside the dishwasher is provided)

8 INSTRUCTIONS FOR THE USER

- water continues to enter the tank due to tank pressure
switch defect
boiler temperature probe disconnected or not working
Check that the water intake tap is on and the dynamic
pressure in the intake system, inspect the water intake
filter and clean if necessary.
If the problem persists:
- boiler pressure switch has failed (continuous empty
reading)
- pipe leaking/disconnected
- check that rinsing spray arm nozzles are clean
- boiler pressure switch has failed (continuous full reading)
- rinsing pump not working
Boiler pressure switch has failed (continuous full reading)
-circuit board relay failure, or
- contactor failure
14