Routine Inspection Of The Spray Arms; Lengthy Periods Out Of Use - Smeg CW520 Manual

Professional dishwasher
Table of Contents

Advertisement

 
 
Remove  the  filters  (simply  lift  them  out  as  shown  here),  taking  care 
that  no  large  residues  fall  into  the  sump  underneath.  Clean  them  to 
remove  residues  and  rinse  with  plenty  of  water,  then  put  them 
correctly back in place; do not use sharp or pointed tools. 
Clean away any limescale deposits to prevent excessive build‐ups; 
If possible, leave the door ajar when not in use;  
Clean  surfaces  thoroughly  and  often  with  a  damp  cloth;  use 
neutral,  non‐abrasive  detergents  which  do  not  use  chlorine 
compounds, which corrode and damage stainless steel.  
Do not use the products mentioned above even when cleaning the floor underneath or in the vicinity of 
the dishwasher,  
to ensure that fumes or drops cannot damage the steel surfaces.  
IMPORTANT: The dishwasher automatically performs program "P0" at the start of the day if water has 
been left in the tank and has dropped below the temperature of 40°C 
11.2   Routine inspection of the spray arms 
Remove the washing and rinsing (top and bottom) spray arms by unscrewing the central screw; remove 
the  rinsing  spray  arms  3  and  remove  the  screws  2  as  shown.  Do  not  unscrew  the  nozzles.  Clean  the 
holes  and  nozzles  under  a  jet  of  clean  running  water;  do  not  use  tools  which  might  cause  damage. 
Reassemble the spray arms with care. 
 
1
 
Clean the outside of the appliance with a damp cloth and neutral soap, rinsing and drying thoroughly. 
11.3   Lengthy periods out of use 
If  the  dishwasher  is  to  be  out  of  use  for  a  fairly  long  period  of  time,  the  detergent  and  rinse  aid 
dispenser devices must be emptied to prevent crystallisation and damage to the pumps: Remove the 
intake hoses from the detergent and rinse aid containers and place them in a container of clean water, 
then perform a few wash cycles followed by a complete pump‐out. 
 
Finally, turn off the master switch, close the water intake valve and leave the door ajar until the interior 
is completely dry. The detergent and rinse aid intake hoses must be put back into the containers when 
the dishwasher is returned to service, taking care not to swap them over (red hose = detergent, blue 
hose = rinse aid). 
 
 
‐ CW 520/530 
 
1
1
 
32 
2
3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cw520dCw530deCw520sdCw530sde

Table of Contents