Changing The Program; Choosing The Program - Smeg CW520 Manual

8.4 Changing the Program
N.B.:
During heating of the water in the boiler and tank with the cycle running, the tank heating element
and boiler heating element symbols may appear on the display.
Filter presence sensor (on some models only)
The filter is fitted with a sensor which checks that it is properly fitted; if it is not in the correct position,
the word "FiLter" appears on the display.
PROGRAM
P1 Glasses
P2 Glasses, cups and plates with light dirt
P3 Very dirty dishes and cutlery
P4 Depending on the duration set.
(*) The cycle duration stated above refers to three‐phase appliances supplied with hot water at
50°C. If the appliance is supplied with cold water, the cycle duration might increase depending

9 CHOOSING THE PROGRAM

TYPE OF DIRT
‐ CW 520/530
With the door closed, to change to a fresh program
instead of repeating the last one, press the
The programs available are displayed.
If a program has already started, press
down to interrupt it.
change the program by pressing
Confirm the program start by pressing
down for 1 second (light L2 changes back to orange).
Short, about 1' 30";
1' with glassware function active.
Average, about 2' 30";
2' with glassware function active.
Long, about 4';
5'30" with sani function active.
As required from 5 to 20'.
27
button.
and hold it
and holding it
DURATION (*)