First Start-Up; Using The Water Softener (On Models With This Feature Only) - Smeg CW520 Manual

First start‐up
The electrical protection system must undergo a functional test before the appliance is put into
operation.
The appliance must be installed and/or inspected by qualified staff, who will start it up for the first
time and provide the relevant operating instructions.
Preparing for use (important)
The rinse aid dispenser is fitted on all models, the detergent dispenser only on some.
If both dispensers are present put the external detergent and rinse aid containers in place and
insert the respective intake hoses on the rear of the appliance into them.
Red hose: detergent
blue hose: rinse aid
As an alternative an external dispenser can be fitted, making the electrical connection by means of
an H05 RN‐F 2x0.5 mm electrical cable, which can be laid along the route shown in the TECHNICAL
DATA diagram and connected as shown in the wiring diagram supplied with the dishwasher.
The dispenser must operate on 230V/50 Hz with maximum power absorption of 15 W.
Connect to the detergent dispenser outside the dishwasher using the red hose mentioned above.
5.1 Using the water softener (on models with this feature only)
The quantity of lime in the water (which indicates its hardness) causes whitish
marks on dry dishes and dishes also tend to lose their shine over time.
The dishwasher is equipped with an automatic water softener which removes the
substances that cause hardness from the water with the aid of regenerating salt.
The first time the dishwasher is used, a litre of water must be poured into the tank
with the salt.
Whenever the tank is filled, always take care to ensure that the cap is firmly
closed.
The mixture of water and detergent must not get into the salt tank, as this would
impair operation of the regeneration system.
In this case warranty cover will be forfeited.

5 FIRST START-UP

Before inserting the hoses into the containers, fit the weights (needed
to ensure that they always draw in liquid from the bottoms of the
containers) and the filters onto their ends as shown.
If the detergent dispenser is not factory‐fitted, it can be retrofitted
after ordering the relative kit.
‐ CW 520/530
13