Table of Contents
Advertisement
Liquiphant M/S (HT), FEL 50 A PROFIBUS PA
Endress+Hauser
6
Commissioning
6.1
Mounting and function check
Make sure that the Mounting and connection checks have been carried out before you
commission your measuring point:
• "Connection check" checklist (see page 16).
6.2
Commissioning with Commuwin II
As soon as you have connected the device to the PA bus and switched on
the power supply, the Liquiphant limit switch is operational. This is indicated
by the green operation LED. If the LED is flashing, then the device is communicating.
The device was preset before leaving the factory.
1. Start Commuwin II and set up the connection to the bus via the server PA-DPV1.
After this, create the device list, define the device address and select "Liquiphant"
by clicking.
2. Click the matrix icons. The Commuwin II operating matrix is displayed.
Fig. 3
Commuwin II user interface
6 Commissioning
29
Advertisement
Table of Contents
