Operation Of The Fqr56; Commissioning; Function Check - Endress+Hauser Soliwave FDR56 Brief Operating Instructions

Commissioning

Setting the selected function
→ The two operating buttons can be used to increase/decrease the value or to switch the
selection.
Example: Function 3 (manual adjustment on free path)
→
→
...
The configured value is stored as soon as the function is switched.
→ The value can be displayed again at any time by selecting the corresponding parameter
configuration function and changed if necessary.
After the parameterization has been completed (i.e. after the microwave barrier has been
adapted to the respective medium), the encoding switch must be returned to the "0" posi-
tion and the FDR56 is now ready for operation.
• The device is in operating mode in encoding switch position "0" only. All other positions are
for parameter configuration.
• In parameterization mode, the microwave barrier continues to operate in the background,
and changed settings are taken into account directly.
• After completing the settings, set the encoding switch back to the initial position "0" (=
operation).
63

Operation of the FQR56

Selection of the switch position 0 to 4 (slightly different operating frequency in each case)
0 0
→ ...
Select the next switch position if the interference is still present.
The switch positions 5 to F have no function, the operating frequency in these positions
corresponds to switch position 0.
7 Commissioning
The microwave barrier is ready for operation a maximum of 3 s after the supply voltage is
applied.
71

Function check

Function check
• "Post-installation check" checklist
• "Post-connection check" checklist
20
oder
→
→
...
Soliwave FDR56/FQR56
Endress+Hauser