Table of Contents
Advertisement
ENGLISH
HOW TO PRESET THE STATION
1. Set the BAND
SELECT
button
to "AM"
or "FM",
and press the TUNING
button to tune the desired
station.
2. Specify the preset buttons
1 ~ 8 or 9 ~
16 or 17 ~ 24 by the SHIFT button.
3. Press the MEMORY buttons and MEMORY indicator lights for about 5 seconds. During this time, press one of the eight PRESET channel
buttons.
4. The channel corresponding to the pressed button is displayed and the indicated frequency
is stored in memory
for that channel.
NOTE:
if preset button is inoperative with MEMORY
illuminated, press MEMORY
and preset buttons again.
@
This model
has a last channel
memory
system.
It stores the last channel
used
power
off.
e
This model is designed to store and retain the stations that have been previously registered in the memory, even if the tuner
is deenergized temporarily. The memory can hold resistered data for approximately about a month [Temperature: 68°F (20°
C), relative
humidity:
65%].
If the memory
is erased
reset the preset data.
PLAYBACK
USING
THE REMOTE
CONTROL
The accessory RC-129 remote control unit is used to contro! the RECEIVER from a distance.
(1)
Inserting the dry cell batteries
Notes on Use of the Batteries
1 Remove the rear cover on the remote control unit.
e The remote control unit uses size R6 (AA) dry cell batteries.
e
The batteries will need to be replaced approximately once a
year. This will depend upon how often the remote control is
used.
e
lf, in less than
a year
from
the time
new
batteries
were
inserted, the remote control fails to operate the receiver from a
near-by position, it is time to replace the batteries.
e
insert the batteries
properly, following
the diagram
on the
remote controi battery supply unit, and making sure to align
the plus and minus sides of each battery.
2 Insert two size R6 (AA) dry cell batteries as shown in the
e Batteries are prone to damage and leakage. Therefore:
diagram on the battery supply unit.
¢
Do not combine new batteries with used ones.
e
Do not combine
different types of batteries.
e
Do not jumper the opposite poles of the batteries, expose
them to heat or break them open, or put them into open
fire.
e When the remote control is not to be used for a long period of
time, remove the batteries from the unit.
e
Ifthe batteries have leaked, remove any battery fluid from the
inside of the battery supply unit by wiping it out thoroughly,
and insert new batteries.
(2)
Directions for use
e
Operate the remote control unit while pointing it towards the
remote control sensor on the receiver as shown in the diagram
left.
e
The remote control unit can be used at distances up to about 8
meters in a straight line from the receiver. This distance will
decrease if there are obstructions blocking the infra-red light
transmission
or if the remote
control unit is not directed
straight at the receiver.
Note on Operation
®
Do not press the operating buttons on the receiver and the remote control unit at the same time. This will cause misoperation.
@
Operation of the remote control unit will become less effective or erratic if the infrared remote control sensor on the receiver is exposed
to strong light or if there are obstructions between the remote control unit and the sensor.
e@ In case you operate your VCR, TV or other components by remote control, do not operate buttons on two different remote control units
at the same
time. This will cause
mis-operation.
Advertisement
Table of Contents
