Table of Contents
Advertisement
e
@
BAND
(Band selector switch)
Press this switch to select the FM
or AM
(MW)
band.
TUNING
(Tuning buttons)
Press these buttons to tune in a station. In the MANUAL
TUNING
mode, each press of the buttons will change the
frequency in 50 kHz steps on FM and 9 kHz steps on AM.
Keeping one of these buttons pressed, the frequency wiil
change until the button is released.
During the AUTO TUNING
mode, pressing one of these
buttons will affect station search up or down the band.
TUNING
MODE
(Tuning
mode
switch)
This switch allows selection between
Auto Tuning and
Manual Tuning.
AUTO TUNING:
Pressing the UP button, the tuner will
begin tuning to a higher frequency and pressing the DOWN
button, it will begin tuning to a lower frequency until a
broadcasting station is found.
MANUAL TUNING:
Stations are tuned in manually by use
of the UP and DOWN
buttons.
DISPLAY
@ @
MW
TIP
CITT
kHz
FM CITC
I Maz
SIGNAL (Signal indicator)
This lights when a station is received.
STEREO /MONO
(Stereo/Mono
indicator)
The STEREO
indicator will automatically
light up when
a
stereo broadcast is received. The MONO indicator will light
up when a broadcast is not being received or at the time of
a monaural broadcast.
TUNING
MODE
(AUTO/MANUAL)
Pressing TUNING
MODE ® causes AUTO and MANU to
light up alternately.
SHIFT
(Shift indicator)
The preset channel which is selected with the Shift Button
@
is displayed by the SHIFT [A] or [B] or [A] BB).
©
ENGLISH
e Tape
selector
(Tape selector
switches)
(DRA-
435R)
TAPE-1:
Press to Select the tape deck con-
nected to the TAPE-1 terminals as the
source.
TAPE-2/VCR:
Press
to select
the
tape
deck
con-
nected to the TAPE-2 terminals as the
source
and
Press
for _ recording/
playback of a Video component
con-
nected
to these terminals.
e TAPE
(Tape monitor
switch) (DRA-335R)
Press this switch (ON) to play TAPE and release (OFF) to
play the source
selected
by the Input selector @.
MEMORY
(Memory
button)
This switch is used to store the desired radio station on a
PRESET CHANNEL button. When pressing this button, the
MEMORY
indicator
lights for approximately
5 seconds.
During this interval, the desired station can be stored in the
memory.
PRESET CHANNEL 1 ~ 24 (Preset Station Buttons)
These buttons are used for storing stations or recalling
stations which have been preset. Using the SHIFT button
you can preset a total of 24 FM or AM stations into preset
channels
1 ~
8, 9 ~
16 and
17 ~
24.
Once a radio has been memorized on
a PRESET CHANNEL
button, the same
station
can
later be tuned
in instantly
simply by pressing the corresponding
PRESET
CHANNEL
button.
CHI [—
1 (7 MEmMo
@
®
REMOTE SENSOR
MEMORY
(Memory
indicator)
This indicator lights for approximately 5 seconds when the
MEMORY
button has been pressed and a station can be
stored
on a PRESET
CHANNEL
button.
CHANNEL
(Preset channel display)
When using the channel preset button @, the channel is
displayed
and the frequency
for that channel
stored
in
memory is displayed in @.
Frequency display (Frequency indicator)
The frequency is displayed in numerals. It is displayed in
MHz for FM and in kHz for AM
(MW).
Advertisement
Table of Contents
