Advertisement
FRONT PANEL FACILITIES
TAPE TRANSPORT MODE INDICATORS
|
| REVERSE MODE SWITCH (REV MODE)
Ss
aes
The indicators shown below indicate the current tape transport status of
Deck | or Deck Il.
TAS
For both Decks | and I
3eFlashing rapidly
1
men
|
Forward mode
Reverse mode
Stop
/
>
|
Playback
Fast forward
—_—_—_—______..
NN
te
Fast reverse
S@Q=
ED
ZEISS
NI ae,
N
Forward
—
<
vere
Es).
eh)
Ray
music search
UTE TINS
LIT
SNS
Reverse
ae
mies
>
yy
eee
music search
&
? & AVES
A 1
ED
For Deck Il only
> £Flashing slowly
Forward mode
Reverse mode
il Tee
| Playback pause
a
Sg 2
<G-5
'
ots
Recording
sae}
+
«ERD | GEG:
Recording
-
Se
Seat
pause
|
Recording
mute
There are three settings:
One way mode
=: position.
When the switch is set to this position, playback or recording (Deck II
only} is performed on one side of the tape only. When the tape reaches
the end of the side, it stops automatically {auto stop function}
Two way mode
=
position
When the switch is set to this position, playback or recording (Deck
only) can be performed on both sides of the tape. When the tape reaches.
the end of the first (forward) side, its direction is automatically reversed,
and playback or recording continues or the other {reverse) side. When it
reaches the end of the reverse side, the tape stops automatically (auto
stop function). If playback or recording is started from the reverse side,
the tape will stop when it reaches the end of the side.
Repeat mode
-»
position
When the switch is set to this position for playback, both sides of the
tape are played back repeatedly until the stop (MB) button is pressed, or
until the tape has been played completely 8 times (16 sides). If any of the
operation buttons are pressed during playback, the repeat mode will be
reset, and the tape will be played eight times (16 sides) when playback is
restarted.
When the switch is set to this position for recording (Deck II only), both
sides are recorded and then the tape stops, as described above for two
way mode.
CONTROL UNIT NOT DESIGNED FOR DOUBLE
DECKS (System remote control)
Selecting Deck |
In order to operate Deck | with the remote control unit, adjust the deck as
follows: With the power off, press and hald the stop (Ml) button of Deck
|, and turn the power on. Continue to hold the stop (Ill) button for ap-
proximately 5 seconds. Deck | can now be operated using the remote
control unit, but Deck Ii cannot.
Switching to Deck tl
To restore remote control operation to Deck il, press the stop (lll) button
of Deck fl_while Deck fl is in stop mode. Deck ll can now be operated
using the remote control unit. Remote control operation can be switched
back and forth between Deck | and Deck |i by pressing the stop (18)
button of the desired deck while it is in stop mode.
NOTE:
ff the power is turned off. or if a power failure or a sudden change in the
power supply {caused by lightning, etc.) occurs, the deck is reset to its
original state. Only Deck if can be operated by remote control. Ta restore
operation to either deck, repeat the above procedure from the beginning.
7
<RRB1087>
Advertisement
