Advertisement
CD-DECK SYNCHRO RECORDING
if the CD player has a program function to determine the order of play-
back, program the CD piayer before beginning this operation.
1.
Load a compact disc in the CD player.
2.
Load the cassette for recording.
® Rewind the tape to the desired starting position.
3.
Set the REV MODE switch.
®@ To record on one side only, set the switch to the =~
position.
To record on both sides, set the switch to either the =) or the
ca) position.
4.
Set the DOLBY NR switch.
5.
Press the play button of the CD player.
6.
Adjust the recording level.
@ See page 10.
7.
Press the stop (Ml) buttons of both the cassette
deck and the CD player.
@ Unless both this deck and the CD player are in stop mode,
synchro recording cannot be performed
8.
Press the CD SYNCHRO button.
®@ The cassette deck begins recording, and the CD player begins
playback.
When the compact disc finishes playing:
The CD player enters stop mode and the cassette deck enters recording
standby mode. Change the disc and press the play button of the CD
player to resume recording. If the CD player does not resume play within
1 minute, the cassette deck enters stop mode.
12
<RRB1087>
When the CD player changes discs (twin tray
or multi-play disc CD players):
The cassette deck enters recording standby mode, and resumes record-
ing when the CD player begins playing the next disc. A 4.5 second blank
space is automatically created between selections.
if the end of the tape is reached while the CD
player is still playing:
The CD piayer returns to the beginning of the currently-playing selection
and then enters pause mode.
To resume recording, load another tape
and check the tape running indicator to ensure that the tape is moving in
the desired direction.
If not, press the playback (Pm or 4) button to
change the tape direction, then immediately press the stop (Il) button,
The tape running indicator will change direction. Synchro recording can
be resumed
by pressing the CD SYNCHRO
button again. (The CD
SYNCHRO
button should be pressed within 1 minute. If more than 1
minute elapses, the CD player will enter stop mode.)
lf the auto-reverse function operates while the
CD is still playing:
The CD player returns to the beginning of the current selection and
enters pause mode.
A 45 second blank space is automatically created on the reverse side,
then the CD player resumes playback and the deck resumes recording.
NOTES:
@
£ven when the CD player is connected to the amplifier with an optical
fiber cable, connect the CD player to either the amplifier or this deck
with pin plug input and output cords.
®
Be sure to connect the deck and the CD player with the COD-DECK
SYNCHRO control cord.
® Although recording begins when the CD
SYNCHRO button is pressed,
the CD player does not start playback until the button is released.
This function can be used to advance the tape past the leader section,
or to create a blank section on the tape.
@
Only PIONEER CD players equipped with a CD'
SYNCHRO jack can be
used for CD -DECK SYNCHRO recording. Any type of CD player which
meets these requirements, including twin-tray or multi-play models,
can be used.
Advertisement
