Advertisement
PLAYBACK
SINGLE PLAYBACK
(Either Deck I or Deck il)
RELAY PLAYBACK
1°
2
(1)
1
26 1
Set the DOLBY
NR switch.
®@ Always set the switch to the same position that was used for
recording.
4.
Set the stereo amplifier for tape playback.
5.
Press the playback (Pm or €) button of either
Deck { or Il.
N=
To stop playback temporarily (Deck II only)
Press the pause ( 11) button.
@
To resume playback, either press the pause ( 11) button again, or
press the playback (> or <) button.
To stop playback
Press the stop (Ii) button.
BLANK SKIP
RELAY
REC OFF PLAY:
Sip
playback.
8
<RRB1087>
1.
Load prerecorded tapes in Deck f and Deck Il.
@ Make sure that both tapes have been recorded using the same
Dolby NR setting.
Set the DOLBY NR switch.
® Always set the switch to the same position that was used for
recording,
3.
Set the REV MODE switch (see page 9).
Set the stereo amplifier for tape playback.
Set the TIMER switch to the PLAY-RELAY/SKIP
position.
6.
Press the playback (> or ¢) button of the deck
that will start to play first.
@ When the tape in one deck ends, the other deck automatically
begins playback.
@ To cancel relay playback, set the TIMER switch to the OFF posi-
tion.
NOTES:
Relay playback can begin from either Deck | or Deck fl.
When the tape in one deck reaches the end, it automatically stops,
and the tape in the other deck begins playback.
When this mode is selected, if the deck encounters an unrecorded
portion of tape more than 15 seconds in length, it will fast forward
the tape until it encounters another recorded portion, and resume play-
back from that point.
To stop playback temporarily (Deck II only)
Press the pause ( 11 ) button.
To resume playback, either press the pause { II) button again, or
press the playback (B or €) button.
To stop playback
Press the stop (ME) button of the deck which is
currently playing.
Advertisement
