Pioneer CT-W430 Operating Instructions Manual

Operating
Instructions
QW PIONEER stenccooune cassette vece CT-W430
ae ea
[| ore ||
cecx |
DOBYA-C NR
AUTO TAPE SELECTOR
aa
(| ore [|| =
CT-W430
CT-W330
OWOEY EE RAEKP) —onevay
Cop) stF NORM ROFF TYPE De
ST =
Sn tye
MODE SPEED] OOLAY NAL
DECK F CONTROL,
TAPE SELECTOR
TAPE COUNTER a woreCicr
Ol reser *RSeeSa
PAUSE — PLAY ws
HIGH SPEED
InyNCHAD COPY
REC Level
== itt
Thank you for buying this Pioneer product.
Please read through these operating instructions. so you will
know how to operate your unit properly. After you have finished
reading the instructions, keep the manual in a safe place for
future reference.
In some countries or regions, the shape of the power plug and
power outlet may differ from that shown in the drawings. How-
ever, the method of connecting and operating the unit is the
same.
WARNING: TO PREVENT FIRE OR SHOCK
HAZARD, DO NOT EXPOSE THIS APPLI-
ANCE TO RAIN OR MOISTURE.
IMPORTANT NOTICE
[For U.S. and Canadian models]
The serial number for this equipment is located on the rear panel.
Please write this serial number on your enclosed warranty card
and keep it in a secure area. This is for your security.
[For Canadian model]
This digital apparatus does not exceed the Class B limits for
radio noise emissions from digital apparatus set out in the Ra-
dio Interference Regulations of the Canadian Department of
Communications.
[Pour le modéle Canadien]
Linterférence, radioélectrique générée par cet appareil nu-
mérique de type B ne dépasse pas les limites énoncées dans
le Réglement sur les perturbations radioélectriques, section
appareil numérique, du Ministére des Communications.
hana! The above illustration shows the CT-W430 for the U.S. and Canadian model.
LINE VOLTAGE SELECTOR SWITCH
Only multi-voitage models are provided with this
switch. U.S:., Canadian, European, U.K., and
Australian models are not provided with this
switch.. .
Mains voltages in Saudi Arabia are 127 V and
220 V only. Never use this model with 110 V set-
ting in Saudi Arabia.
The line voltage selector switch is on the rear panel. Before your
model is shipped from the factory, this switch is set to the power
requirements of the destination..Check that it is set properly
before plugging the power cord into the AC wall socket. If the
voltage is not properly set or if you move to an area where the
voltage requirements differ, adjust the selector switch as follows.
1. Disconnect the power cord.
2. Insert a medium-size screwdriver into the groove on the volt-
age selector.
3. Adjust so that the tip of the arrow points to the voltage value
of your area.
Set the voltage selector
for the voltage in your area.
Medium-size screwdriver
"This product complies with the Radio Interference require-
ments of the EC (European Community} Directive 87/308/EEC."
Y PIONEER'
The future of sound and vision. .