ICON Health & Fitness PRO-FORM 10 K Cooling Breeze User Manual page 6

Assembly requires two persons. Hace the treadmHUin a cbared area and remove aH packing matedaUs, Do not
dispose of the packing matedaUs until the treadmHUis assembbd,
Note: The underside of the treadmHUwaUking beUtis coated with high-performance Uubdcant, During shipping, a
small amount of Uubdcant may be transferred to the top of the waUking beUt,the sides of the waUking pUatform, or
the shipping carton, This does not affect treadmHUperformance, ff there is Uubdcant on top of the waUking beUtor
on the sides of the walking platform, wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner,
Assembly requires the included allen wrench _ and your own philtips screwdriver (_.
_ _z:::::::::::::::::_
With the help of a second person, carefully raise the
Uprights (65) to a vertical position,
Have the second person hold the consob assembly near
the Uprights (65) as shown, Look under the console as-
sembly and locate the Console Wire Harness (71),
Cut the plastic ties securing the Upright Wire Harness
(85) to the right Upright (65), Connect the Upright Wire
Harness to the Console Wire Harness (71), Make sure to
connect the connectors properly (see the inset draw-
ing}. The connectors should slide together easily and
snap into ptace. If the connectors do not slide together
easily and snap into place, turn one connector and try
again, IF THE CONNECTORS ARE NOT CONNECTED
PROPERLY, THE CONSOLE MAY BE DAMAGED
WHEN THE POWER IS TURNED ON.
Console
Assembly,
insert the excess Wire Harness (71,85) into the right
Upright (65),
Set the console assembly on the Uprights (65), While a
second person holds the console assembly, attach the
console assembly with four Console Bolts (99), four
Console Washers (69), and four Console Star Washers
(29) as shown, Firrnty tighten the Consote Bolts.
Console
Assembly
29 69
6