Ic Statement - Quectel AF51Y Hardware Design

Wi-Fi&Bluetooth Module Series
This device is intended only for OEM integrators under the following conditions:
(For module device use)
1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and
2) The transmitter module may not be co-located with any other transmitter or antenna. As long as 2
conditions above are met, further transmitter test will not be required. However, the OEM integrator is still
responsible for testing their end-product for any additional compliance requirements required with this
module installed.
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20 cm between the radiator &
your body.

7.3. IC Statement

This device complies with Industry Canada's licence exempt RSSs. Operation is subject to the following
two conditions: (1) This device may not cause interference; and (2) This device must accept any
interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'lndustrie Canada applicables aux appareils radio exempts
de licence.
L'exploitation est autorisée aux deux conditions suivantes (1) l'appareil ne doit pas produire de brouillage,
et.
(2) I' utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
This device complies with the Canadian ICES-003 Class B specifications. CAN ICES-3(B)/ NMB-3(B).
Cet appareil numérique de la Canadian ICES-003. Cet appareil num rique de la classe B est conforme à
la norme NMB-003 du Canada.
AF51Y_Hardware_Design 48 / 47