Worning; Important Notice To Oem Integrators - Quectel AF51Y Hardware Design

Table of Contents

Wi-Fi&Bluetooth Module Series

Worning

1. This module is limited to OEM installation ONLY.

2. This module is limited to installation in fixed applications, according to Part 2.1091(b).

3. The separate approval is required for all other operating configurations, including portable

configurations with respect to Part 2.1093 and different antenna configurations

4. For FCC Part 15.31 (h) and (k): The host manufacturer is responsible for additional testing to verify

compliance as a composite system. When testing the host device for compliance with Part

15 Subpart B, the host manufacturer is required to show compliance with Part 15 Subpart B while the

transmitter module(s) are installed and operating. The modules should be transmitting and the evaluation

should confirm that the module's intentional emissions are compliant (i.e. fundamental and out of band

emissions). The host manufacturer must verify that there are no additional unintentional emissions other

than what is permitted in Part 15 Subpart B or emissions are complaint with the transmitter(s) rule(s).

The Grantee will provide guidance to the host manufacturer for Part 15 B requirements if needed.

Important Note

Important Note notice that any deviation(s) from the defined parameters of the antenna trace, as

described by the

instructions, require that the host product manufacturer must notify to Quectel Wireless Solutions Co.,

Ltd.. that they wish to change the antenna trace design. In this case, a Class II permissive change

application is required to be filed by the USI, or the host manufacturer can take responsibility through the

change in FCC ID (new application) procedure followed by a Class II permissive change application.

End Product Labeling

When the module is installed in the host device, the FCC/IC ID label must be visible through a window on

the final device or it must be visible when an access panel, door or cover is easily re-moved. If not, a

second label must be placed on the outside of the final device that contains the following text: "Contains

FCC ID: XMR202201AF51Y"

The FCC ID can be used only when all FCC mpliance requirements are met.

AF51Y_Hardware_Design

46 / 47

Table of Contents