Etekcity EL11, EL11H - Digital Luggage Scale Manual

Specifications

• Room temperature display
• Easy-to-read LCD display (0.44" digits)
• Capacity: 50 kg (110 lb)
• Graduation: 50 g (0.1 lb)
• Battery: 1 x 3 V CR2032 (lithium)
• Low battery and overload indication

Cleaning & Maintenance Notes

• Use a slightly damp cloth to clean the scale. Do not immerse the scale in water or use chemical cleaning agents.
• Ensure that there is no stress on the triangle ring when not in use.

Function Diagram

Button Functions

• : Turns the scale on or off (hold for 2 seconds to turn off).
• UNIT: Switch between the weight and temperature measurement units.

Installing & Replacing the Battery

Battery Holder

• Use a screwdriver to loosen the screw.
• Hold the scale in one hand, and slide out the battery holder with the other hand.
• Push corner A on the battery holder outward to release the battery.
• Insert the new battery under notches B and C. Press the other side of the battery until it clips into corner A.
• Insert the battery holder back into the scale.
• Use a screwdriver to tighten the screw.

Note:

• Remove the battery insulation strip for the first use.
• Battery type: 1 x 3 V CR2032 lithium battery.
• The LCD will display "Lo" when the battery power is low. When this occurs, you should replace the battery as soon as possible.

Weighing

1. Press the POWER button to turn on the scale.
2. Press UNIT to select the weight unit, if needed. If the scale does not display 0, ensure there is no stress on the triangle ring and press the Z/T button.
3. Strap the belt on the scale through the luggage handle and secure the hook of the belt on the triangle ring.
4. Lift the scale gently, making sure it is horizontal and balanced. Wait until the weight reading stabilizes, flashes 3 times, and locks. The scale will display the reading for 2 minutes, then shut off if no button is pressed.
5. To weigh again, remove the luggage or let the belt go slack and press Z/T to reset the display to 0.

Reading Temperature

1. Press the POWER button to turn on the scale. When the LCD displays 0, press UNIT to switch to temperature mode.
2. The LCD will display "--" and then display the current ambient temperature.

Warranty Information

If you have any questions or concerns about your new product, please contact our helpful Customer Support Team.

Etekcity Corporation
1202 N. Miller St., Suite A
Anaheim, CA 92806
USA

Email:
support.uk@etekcity.com
support.de@etekcity.com
support.es@etekcity.com
support.fr@etekcity.com
support.it@etekcity.com
support.eu@etekcity.com

*Please include your order ID when contacting customer support.

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Etekcity EL11, EL11H - Digital Luggage Scale Manual