Ignition Mode; Connecting To A Satellite Receiver; Power Consumption - Maxview Target MXL017 Installation & Operating Instructions Manual

Hide thumbs Also See for Target MXL017:
Table of Contents

Advertisement

4. Satellite Found
Once the satellite has been found the OK LED and the satellite selected will show solid green.
5. Park System
PARK - Press and hold for 3 seconds. LED's 1 to 5 flash green to indicate system is collapsing.
Once fully collapsed, control panel can be powered off.

Ignition mode:

The ignition mode is a safety feature that automatically lowers the antenna and prevents accidental operation
whilst travelling. When the Target has detected an active ignition circuit in the vehicle the antenna is
automatically lowered.
Note: The Control Box must be wired to a 12v DC electrical circuit that is live when the vehicle's ignition is on.
This not only provides a safety benefit but also refreshes the Control Box memory which allows the Target to
perform correctly.

Connecting to a Satellite Receiver:

The satellite cables must connect to the Control Box. The Control Box will then output this signal through the
F connector marked 'RECEIVER'. In order for the satellite signal to pass through the Control Box the power must
be on.

Power consumption:

The Target has been designed to minimise power consumption.
When the Target is not used for long periods of time it is recommended to switch off the Control Box.
The Ignition Mode will still activate even with the Control Box power switch in the off position.
When power is restored to the system the antenna will automatically lower into the park position.
Visit: www.maxview.co.uk - Search 'Target' for potential software updates
Page 14
Solid green
Flashes green
Solid green
Park

Advertisement

Table of Contents
loading

This manual is also suitable for:

Target mxl050Target mxl065Target mxl085

Table of Contents