Table of Contents
Advertisement
3. Read the next three windows that open, and click Next; then, from the Cluster
4. Select The first node in the cluster; then, click Next.
5. In the Cluster Name field, type a unique name for the cluster; then, click Next.
6. When the select an account screen opens, enter a username and password, type
7. When the Cluster Service Configuration Wizard Configure Cluster Networks win-
8. Several Cluster Service Configuration Wizard Network Connections windows
9. Mark the Enable this network for cluster use checkbox; then, for the Local Area
10. When the window opens containing the IBM Netfinity Fault Tolerance PCI Adapter
11. Mark the Enable this network for cluster use checkbox; then, for the Local Area
12. Ensure that the private network is at the top of the network list; then, click Next.
13. Type the IP address of the cluster (see "Collecting network information" on page
14. Click Finish to complete the cluster service configuration; then, click OK when
15. Click Next. In the next window, select ipsha disk Q drive as the quorum drive;
16. Click Finish to complete the ServeRAID configuration; then, click Finish to com-
Proceed to "Configuring Server 2" to continue configuring your cluster.
Configuring Server 2
Use this procedure to configure Server 2.
1. Open a command prompt on Server 2 and then type
2. When the IBM ServeRAID Cluster Solution window opens, click OK; then, from
3. Click Next until the Cluster Service Configuration Wizard window opens. Read
4. Select The second node in the cluster; then, click Next.
20
IBM® xSeries 340 HA Cluster: Installation Guide
Service Configuration Wizard window, read the agreement, select I Understand
and then click Next. The Cluster Service Configuration Wizard Create or Join
Cluster window opens.
the name and password of the domain administrator account; then, click Next.
dow opens, read the information and click Next.
open, when the window opens containing the IBM 10/100 Ethernet Server
Adapter in the device field, change the network name to private.
Connection 2, select internal use only and click Next.
in the device field, change the network name to public.
Connection 2, select all communications (mixed network) and click Next. The
Cluster Service Configuration Wizard Internal Cluster Communication window
opens.
The Cluster Service Configuration Wizard Cluster IP Address window opens.
12); then, click Next.
the cluster service starts. The IBM ServeRAID Cluster Configuration Wizard win-
dow opens.
then, click Next.
plete the cluster configuration.
cd\ibm\cluster
and press Enter; then, type
setup
and press Enter.
the Welcome window, click Next to start the ServeRAID Cluster Configuration
Wizard.
the agreement, select I Understand, and then click Next. The Cluster Service
Configuration Wizard Create or Join Cluster window opens.
Advertisement
Table of Contents
