Operation; Stand-Alone Mode; Interconnecting Several Devices (Master/Slave Operation); Control Board - EuroLite Multiflood IP 8x10W RGBW Wash CRMX User Manual

OPERATION

After connecting the device to the mains it is ready for operation. The display indicates the last operating mode.
The operating modes can be selected by means of the display and the control buttons. All settings remain stored
even if the device is disconnected from the mains. The device can be operated in stand-alone mode via the control
board and controlled via remote control (EUROLITE IR-38), DMX signal and W-DMX signal.

Stand-alone mode

In the stand-alone mode, you can do without a controller. Disconnect the device from the controller and call the
desired setting. Please refer to the instructions under Control Board.

Interconnecting several devices (master/slave operation)

Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled with the
master unit without the need for a DMX controller. The devices must be set to the corresponding operating modes.
1. Configure all slave units before connecting the master unit: Press the MENU button so many times until
"MASTSLAV" is indicated on the display. Confirm with the ENTER button. Set "Slave" on all slave units with
the UP and DOWN buttons. Confirm with the ENTER button. Set "Master" on the master unit using the UP and
DOWN buttons. Confirm with the ENTER button.
2. Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the DMX
output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been connected
in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller to the DMX input
of the master unit.
3. Set the master unit to the desired operating mode. The interconnected devices will now operate synchronously.

Control Board

The Control Board offers several features: you can easily set the starting address, run the pre-programmed
program or select a DMX channel mode.
The main menu is accessed by pressing Menu. Browse through the menu by pressing Up or Down. Press Enter in
order to select the desired menu. You can change the selection by pressing Up or Down. Press Enter in order to
confirm. You can leave every mode by pressing Menu. The functions provided are listed in the following sections.
If you press and hold Up or Down, the values change faster. The device has an automatic storage for all settings.
When you switch the device off and on again, it will operate with the previously set values.
Default settings in bold
MAIN level Menu level
DMX Addr 001-512
3CH, 4CH, 6CH, 8CH,
DMX Chan
11CH
OFF/Dim1/Dim2/
Dimmer
Dim3/Dim4
Mast/Slav Master/Slave
CRMX – ON/OFF
Wireless
Unlink
Description
DMX address setting
Setting DMX channel mode
Dimmer speed (step response)
OFF: Response characteristics of LEDs
Dim1: Response characteristics of halogen lamps, fast
Dim2: Response characteristics of halogen lamps, less fast
Dim3: Response characteristics of halogen lamps, middle
Dim4: Response characteristics of halogen lamps, slow
Master/Slave mode
(Master:control without external controller)
(Slave: control with external controller)
Switch wireless CRMX receiver on or off
ON: Activate CRMX (display indication:
OFF: Deactivate CRMX (display indication:
Disconnect
Press ENTER for 3 seconds to delete the wireless CRMX connection.
27/36
CRMX activated)
CRMX deactivated)
00151618, Version 1.0