Installation; Changing The Beam Angle - EuroLite Multiflood IP 8x10W RGBW Wash CRMX User Manual

INSTALLATION

WARNING! Risk of injury caused by falling objects
Devices in overhead installations may cause severe injuries when crashing down. Make sure that the
device is installed securely and cannot fall down. The installation must be carried out by a specialist
who is familiar with the hazards and the relevant regulations.
The device may be placed on the floor or fastened to a truss or similar rigging structure. The device must never be
fixed swinging freely in the room.
1 The rigging structure must support at least 10 times the weight of all fixtures to be installed on it.
2 Block access below the work area and work from a
stable platform when installing the device.
3 Use rigging hardware that is compatible with the
structure and capable of bearing the weight of the
device. Please refer to the "Accessories" section for a
list of suitable rigging hardware. Screw a clamp via a
M10 screw and self-locking nut onto the Omega
bracket. Insert the two quick-lock fasteners of the
Omega bracket into the respective holes on the bottom
of the device. Tighten the quick-lock fasteners fully
clockwise.
4 Secure the device with a safety bond or other
secondary attachment.
attachment must
accordance with the latest industrial safety regulations
and constructed in a way that no part of the installation
can fall down if the main attachment fails. Use the hole
in the bracket for fixation of the safety bond. Fasten the
safety bond in such a way that, in the event of a fall, the
maximum drop distance of the device will not exceed 20
cm.
5 To align the device, release the fixation levers at the
mounting bracket, adjust the desired inclination angle
and tighten the fixation levers.
6 After installation, the device requires inspections periodically to prevent the possibility of corrosion, deformation
and looseness.

Changing the beam angle

With the delivery of the device you will receive a frost filter, with which the beam angle can be changed from 10° to
approx. 25°. If present, please remove the protective foil of the frost filter when using it for the first time. If you want
to change the beam angle of the device, attach the filter using the folding latch on the front of the device. Make
sure that the frost filter is firmly attached to avoid accidental loosening of the frost filter.
This secondary
be sufficiently dimensioned
(1) Safety bond
(2) Clamp
(3) Omega bracket
(4) Quick-lock fastener
1
safety
in
25/36
2
3
4
00151618, Version 1.0