Audi Q5 2011 Owner's Manual page 34

32 Driver information display
~ - Steer ing malfunction
If there is a malfunction in the electronic
steering column lock, the steering cannot be
unlocked.
If the . symbol in the display blinks, there
is a malfunction in the electronic steering col-
umn lock. A driver message appears as well to
explain the malfunction in more detail. The
driver warning goes out after about 5 sec-
onds, but it can be brought up at any time by
pressing the
ISETI
button again.
Do not drive vehicle: steering defective
• Contact your nearest authorized Audi dealer.
• Do
not
tow your vehicle .
A
WARNING
, _
-
Your vehicle must not be towed in the
event of a malfunction in the electronic
steering column lock because it cannot be
steered due to the locked steering. If it is
towed with the steering locked, there is
the risk
of
an accident.
© -
Ignition lock malfunction
A malfunction in the ignition lock must be re-
paired immediately.
If the . symbol in the display blinks, there
is a malfunction in the electronic ignition lock.
A driver message appears as well to explain
the malfunction in more detail. The driver
warning goes out after about 5 seconds, but it
can be brought up at any time by pressing the
ISETI
button again.
Ignition lock defective. Contact workshop !
• Do not turn the engine off.
• Drive immediately to an authorized Audi
dealer to have the malfunction corrected.
If there is a malfunction in the electronic igni-
tion lock , the ignition cannot be turned off.
Drive immediately to an authorized service fa-
cility to have the cause of the malfunction cor-
rected .
On vehicles with Convenience key*, the engine
should not be switched off using t he Start/
Stop button because the engine cannot be
started again after the ignition has been
switched off.
Yellow symbols
Aye/low symbol means WARNING.
Fig. 25 Display: Yellow warning symbol
Yellow symbols indicate a priority
2
malfunc-
tion -Warning!
When a yellow warning symbol appears,
one
warning tone sounds . A driver message ap-
pears as well to explain the malfunction in
more detail. The driver warning goes out after
about 5 seconds, but it can be brought up at
any time by pressing the
ISETI
button again.
Check the function displayed as soon as possi-
ble. The yellow symbol will not go out again
until the reason for the malfunction has been
corrected.
If several priority 2 malfunctions are present,
the symbols appear in succession and remain
for about 2 seconds.
~ ~
Dynamic steering*
¢ page 33
IJ
Worn brake pads
¢page34
r.
Battery voltage
¢page 35
1:1
Defective light bulb
¢page3 4