Table of Contents
Advertisement
24
Dr ive r information
display
Operation
The trip computer is controlled by two
switches on the windshield wiper lever.
~-------< ®
Fig. 17
Windshie ld wipe r lever: cont rols for th e t rip
com pute r
• To display the trip computer memory leve ls,
press the
I
RES ET
I
button @ ¢
fig. 17
re-
peatedly until the desired memory level is
shown in the d isplay.
• To d isplay trip information within a memory
level, press the top or bottom part of the
function selec t ion switc h
@.
The trip computer will not operate unless the
ignit ion is on. When you turn on the ignition,
the function that was in use when you last
turned the ignition off will be d isp layed .
In addition to information on the trip comput-
e r (trip computer 1, 2 and efficiency pro-
gram*, the digita l speedometer
and informa-
tion regarding the navigation system* can al-
so be displayed. To switch the display between
the different information, tap the
I
RESE T
I
but-
ton ® briefly .
Setting values to zero
To delete one current value from t he trip com-
puter, select the desired function and press
the
! RESE T
I
button ® for at least one second .
The following values can be set to zero indi-
vidually :
- Average fuel mileage
- Average speed
- Elapsed time
- Distance
All currently displayed values are deleted in
the efficiency program* .
In addition, all the values in the sing le-trip or
the total-trip memory can be deleted simulta -
neously ¢
page 24 .
(D
Tips
All stored va lues will be lost if the vehicle
battery is disconnected.
Basic Settings for the trip computer
The
MMI*
or the radio operating unit is used
for setting the trip computer's basic settings .
• Select: Function button
! CAR ! >
Instrument
cluster> On-board computer 1
or
On-board
computer 2 .
The values in the sing le-tr ip or the total-trip
memory can all be reset to zero at the same
time under Reset in the men u.
In add ition, you can determi ne what informa-
tion from the trip computer should be shown
in the instrument cluster disp lay. If one of the
pieces of driver info rmation is turned
Off,
that
driver information will not be shown in the
display. The information will continue to be
calculated by the trip computer and can be
turned back On at any time.
(I}
Tips
The driving information in the efficiency
program* is also reset to zero with the sin-
gle-trip memory.
Efficiency
program
Description
Applies to veh icles : with efficiency program
Fig. 18
Disp lay: efficiency program
Advertisement
Table of Contents
