Advertisement
Check tension
and repeat above pro-
cedure until desired tension is obtained.
Reattach/assemble
outboard support to
reel. (See Page 3, Steps Q thru S).
ATTACHING CONNECTING
HOSES
To prevent
damage
to connecting
hose when installing
hose to reel,
sufficient clearance must be provided
from outside edge of sheave.
See Figure (2). Remove U-keeper and
inlet adapter from swivel body.
Assemble swivel adapter to connecting
hose.
Reconnect
inlet adapter to swivel body
and replace U-keeper.
Connect other end of connecting hose to
material
supply
line
source
or
connection.
REEL INSTALLATION AND
ADJUSTMENT
See Figure (3). The guide arm may be
positioned in 22-1/2 degree increments.
For ease of operation
and increased
hose life, the guide
arm should
be
positioned
to minimize
hose strain as
the delivery hose is pulled through the
roller outlet.
Three studs must be used to securely
attach the guide arm. It may be neces-
sary to change the position of the hex
head screw and one stud in order to
obtain the desired guide arm position.
The hose clamp must be relocated if the
guide arm is repositioned
SAFETY INFORMATION
Read
and understand
all warnings,
cautions and instructions
before operat-
ing this equipment.
Extreme
caution
should
be used when operating
this
equipment
as personal
injury
and/or
properly damage can result from equip-
ment misuse.
Adequate
personal
pro-
tection
is recommended
to prevent
splashing of material on the skin or in the
eyes. ALWAYS disconnect
air coupler
from pump when the pump is not being
used.
PRESSURE RELIEF
PROCEDURE
Always perform
this procedure
when the
pump
is shut off and before
checking,
servicing,
installing,
cleaning
or repairing
any part of this system.
Perform the following procedure:
A.
B.
C.
Disconnect the air supply to
the pump.
Point the dispensing valve
away from yourself and others.
Open the dispensing valve
into an appropriate
container
until the pressure is relieved.
If the above procedure does not relieve the
pressure, the dispensing valve or hose may
be restricted.
To relieve the pressure, very
slowly loosen the hose end coupling.
Then
loosen completely and clear the dispensing
valve and/or hose.
INSPECTION
Prior to operation or maintenance
a visual
inspection
shall be made.
Check reel
system for leaks, worn or missing parts.
Any reel that appears to be damaged
in
any way, is badly worn or operates
ab-
normally shall be removed from use until
repairs
are made.
Contact
factory
au-
thorized service center for repairs.
If overpressurizing
of the equipment
is
believed to have occurred, contact a fac-
tory authorized
service center for inspec-
tion of the reel.
Annual inspection by a factory authorized
service center is recommended.
DISASSEMBLY
To disassemble,
perform
ASSEMBLY
procedures
in reverse.
REPAIR
Repair is limited to replacement
of listed
service
parts.
Special
procedures
and
tools are required.
Contact Lincoln Cus-
tomer Service, One Lincoln Way, St. Louis,
MO 63120-1578,
(314) 679-4300 for your
nearest authorized service center.
When ordering
replacement
parts, list:
part number,
description,
model number
and series letter.
5
LIMITED
WARRANTY
Lincoln, A Pentair Company, warrants that
lubrication equipment, materials dispensing
equipment
and other related equipment
manufactured by it will be free from defects
in material and workmanship during the one
(1) year following the date of purchase.
If
equipment proves to be defective during this
warranty
period,
it will be repaired
or
replaced
without
charge, provided
that
factory examination indicates the equipment
to be defective.
To obtain
repair
or
replacement,
it
must
be
shipped,
transportation charges prepaid, with proof of
date of purchase to a Lincoln authorized
Warranty and Service Center, within the one
(1) year following the date of purchase.
This warranty is extended to the original
retail purchaser only. This warranty does
not apply to equipment
damaged
from
accident,
overload,
abuse,
misuse,
negligence, faulty installation or abrasive or
corrosive materials, or to equipment repaired
or altered
by anyone not authorized
by
Lincoln to repair or alter the equipment. This
warranty applies only to equipment installed
and
operated
according
to
the
recommendations of Lincoln or its authorized
field personnel. No other express warranty
applies to lubrication equipment, materials
dispensing
equipment,
and other related
equipment manufactured by Lincoln.
ANY IMPLIED WARRANTIES applicable to
lubrication equipment, materials dispensing
equipment,
and other related equipment
manufactured by Lincoln INCLUDING THE
WARRANTIES
OF MERCHANTABILITY
AND FITNESS
FOR A PARTICULAR
PURPOSE, WILL LAST ONLY FOR ONE
(1)
YEAR
FROM
THE
DATE
OF
PURCHASE.
SOME STATES DO NOT
ALLOW LIMITATIONS ON HOW LONG AN
IMPLIED WARRANTY
LASTS, SO THE
ABOVE LIMITATION MAY NOT APPLY TO
You.
In no event shall Lincoln
be liable for
incidental or consequential damages. The
liability of Lincoln on any claim for loss or
damage arising out of the sale, resale, or
use of lubrication
equipment,
materials
dispensing
equipment,
and other related
equipment
shall in no event exceed the
purchase price. SOME STATES DO NOT
ALLOW THE EXCLUSION OR LIMITATION
OF INCIDENTAL OR CONSEQUENTIAL
DAMAGES, SO THE ABOVE LIMITATION
OR EXCLUSION
MAY NOT APPLY TO
YOU.
THIS WARRANTY GIVES YOU SPECIFIC
LEGAL RIGHTS AND YOU MAY ALSO
HAVE OTHER RIGHTS WHICH VARY
FROM STATE TO STATE.
Advertisement
