Advertisement
Contents
Safety . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installation . . . . . . . . . . . . . . . . . . . . . . .
Adjustments . . . . . . . . . . . . . . . . . . . . .
Service instructions . . . . . . . . . . . . . . .
Parts list . . . . . . . . . . . . . . . . . . . . . . . . .
Warranty . . . . . . . . . . . . . . . . . . . . . . . .
Specifications
Maximum operating pressure
Maximum operating temperature
Inlet
Outlet
Reel capacity
Application
Wetted seal type
Swivel type
Dimensions
A
note
Read this manual carefully before installing,
operating or servicing this equipment.
Safety
2
3
4
Personal injury and/or equipment damage
4
may result if proper safety precautions are
5
not observed.
8
• Do not connect inlet or output hoses if reel
is not properly installed.
• Slowly release fluid/gas pressure from
system before servicing reel.
• Do not connect supply to reel with any
source that exceeds maximum operating
pressure of reel.
Model 89015
5 000 PSI (344 bar)
210 °F (99 °C)
/
in NPT internal
3
8
/
in NPT internal
3
8
50 ft. x
/
in SAE 100R2
3
8
Grease
Aflas
Ball bearing
C
B
• Use caution at all times, pressurized hoses
are very dangerous and can cause per-
sonal injury or death.
• Be aware of machinery and personnel in
work area.
• Remove system pressure immediately if a
leak occurs in the hose or reel.
• Exercise extreme caution with high
tension spring assembly contained in the
reel.
• Pull hose from reel by grasping the hose,
not the control valve.
• Do not pull or jerk on hose if reel stops
unwinding or winding. Remove system
pressure immediately.
• Observe all common safety practices.
Table 1
Fig. 1
Dimensions
A
D
B
C
D
E
F
E
F
2
Table 2
16.5 in (419,1 mm)
17 in (431,8 mm)
8 in (203,mm)
4 in (101,6 mm)
7 in (177,8 mm)
0.438 in (11,125 mm)
Advertisement
