Advertisement
MODELS 91030, 91031, 91032, 91033 & 91034
Hose Reels
IMPORTANT
Read this manual carefully before installing, operating
or servicing thisequipment.
Safety Precautions
Personal injury and/or equipment damage may result if proper
safety precautions are not observed.
•
Ensure that only a qualified electrician installs/services this
equipment.
•
Ensure that power supply voltage does not exceed maxi-
mum voltage rating of reel.
•
Ensure that reel is properly installed before connecting to
power supply.
•
All cord reels with GFCI receptacles must be hard wired to
ensure proper function.
•
Ensure that all electrical power is removed from reel be-
fore servicing.
•
A high-tension spring assembly is contained within the
reel. Exercise extreme caution.
•
Check for frayed and/or broken wires before each use.
Pull electrical cord from reel by grasping the electrical cord
itself, not the work device.
•
If an electrical malfunction should occur, remove power
from reel immediately.
•
Ensure that reel, electrical cord, and equipment being ser-
viced are properly grounded. Use an ohmmeter to check
ground continuity.
•
If reel ceases to unwind or rewind, remove power immedi-
ately. Do not pull or jerk on electrical cord!
•
Treat and respect the reel as any other piece of machinery,
observing all common safety practices.
Electrical Information
Part Number Voltage A/C AMPS
91030
91031
91032
91033
91034
Frequency 60HZ single phase
Even low voltage can cause irreparable damage or death!
Exercise extreme caution whileoperating or servicing this
equipment.
Page Number - 2
To order call 1-800-548-1191 or visit www.partdeal.com - info@partdeal.com
125
13
125
20
125
20
125
0.3
125
10
Dimensional Data
A
13 1/4"
B
12 5/8"
C
8"
D
2 1/2"
E
9 3/8"
F
1 1/4"
Installation Instructions
Mounting
CAUTION: Unless reel was speci-
fied differently when ordering, maxi-
mum installation height is 16
feet. Do not exceed this distance.
Ensure that only a qualified electri-
cian installs/services this equip-
ment. Installation of GFCI cord
reels should be performed
by a qualified and licensed profes-
sional in accordance with building
codes and applicable NEC
standards.
1.
Unpack and inspect reel for damage. Turn by hand to
check for smooth operation. Check for completeness.
2.
Configure reel for top, side or bottom-wind (bottom-wind for
constant tension reels only) electrical cord dispensing by
removing bolts (1), securing guide arm bracket (2). Deter-
mine new guide arm location and remove corresponding
bolts. Position guide arm bracket to reel and replace bolts.
3.
Position reel on floor, wall, or ceiling. Secure into place,
using four (customer supplied) screws or bolts (3).
Electrical
Ensure that application does not exceed electrical rating of
reel. Observe applicable NEC, OSHA, and local electrical
codes when installing this equipment.
1. Connect input cord to grounded receptacle.
Form 404371
Advertisement
