Summary of Contents for Hauff-Technik ESH Basic FUBO SR1 BHP
Page 1
Immer. Sicher. Dicht. Montageanleitung - ESH Basic FUBO SR1 BHP Einsparten-Bauherrenpaket für Gebäude ohne Keller. Installation instructions - ESH Basic FUBO SR1 BHP Single-line building package for buildings without base- ment. BAUHERRENPAKET BUILDING PACKAGE Vor Beginn der Montage Anleitung lesen und gut aufbewahren! Read the instructions prior to installation and keep them in a safe place! ...
Page 6
• Die Lagerung des Einsparten-Bauherrenpaketes muss so erfolgen, dass dieser • Die Position der ESH Basic FUBO SR1 BHP ist grundsätzlich mit den Energiever- keinen zu niederen Temperaturen (<5 °C) und höheren Temperaturen (>30 °C) sorgern abzustimmen! sowie keiner direkten Sonneneinstrahlung ausgesetzt ist.
Page 7
> 5 cm). Disposal • The position of the ESH Basic FUBO SR1 BHP must be agreed upon with the energy suppliers! If no return or disposal agreement has been concluded, recycle dismantled com- • The basic unit must not be covered by the inner walls later (shell wall + plaster).
Page 8
Einsparten-Bauherrenpaket ESH Basic FUBO SR1 BHP • Metal remains are to be scrapped according to existing environmental regulati- ons. • Dispose of elastomers according to existing environmental regulations. • Dispose of plastics according to existing environmental regulations. • Dispose of packaging material according to existing environmental regulations.
Tel. +49 7322 1333-0 (Grundkörper) +49 7322 1333-999 E-Mail office@hauff-technik.de Bemaßung: ESH Basic FUBO SR1 BHP (siehe Abb.: 2 und Internet www.hauff-technik.de Legende zu Abb.: 2 Die Vervielfältigung der Montageanleitung - auch aus- Grabensohle zugsweise - als Nachdruck, Fotokopie, auf elektronischem 1500 mm Datenträger oder irgendein anderes Verfahren bedarf un-...
Einsparten-Bauherrenpaket ESH Basic FUBO SR1 BHP 7 Grundkörper montieren die Flügelschraube feststellen und damit den Aufbau fixieren (siehe Abb.: 11) Vormontierten Wassersperrflansch, auf der Aufstell- Der mit der Aufstellvorrichtung fixierte Grundkör- vorrichtung ca. 15 cm ab Rohrkante, positionieren per stellt noch keine absolute Stabilität dar. Be- (siehe Abb.: 5).
Einsparten-Bauherrenpaket ESH Basic FUBO SR1 BHP 9 Manschettenstopfen montieren Beachten Sie dazu Punkt 12 "Verlängerungsset mon- tieren". Die Montage des Manschettenstopfens erfolgt am 11 Nach der Höhenfixierung des Grundkörpers und wäh- Rohrende des Spiralschlauches Hateflex14078 MRD rend des Auffüllens mit Sand, kann mithilfe der vor- oder am Ende des verlängerten Rohrsystems.
Einsparten-Bauherrenpaket ESH Basic FUBO SR1 BHP Wird eine Gasarmatur installiert, muss das vormon- tierte Sekundärdichtelement ausreichend mit Gleit- mittel GMT eingestrichen werden (siehe Abb.: 28). Legende zu Abb.: 28 Sekundärdichtelement Einzeldichtelement oder Gashauseinführung in den Dichteinsatz einführen. Anschließend die Laschen des Dichtelements mit den Kunststoffschneidschrauben soweit anziehen, bis sie bündig an der Innenplatte der...
Page 13
Robert-Bosch-Straße 9 89568 Hermaringen, GERMANY 5 Dimensions of ESH Basic FUBO SR1 BHP (basic unit) Tel. +49 7322 1333-0 Dimensions: ESH Basic FUBO SR1 BHP (see Figs.: 2 and 3). +49 7322 1333-999 E-mail office@hauff-technik.de Legend for Fig.: 2 Internet www.hauff-technik.de...
Single-line building package ESH Basic FUBO SR1 BHP 7 Installing the basic unit Insert spiral hose system from the bottom into the o- pening of the basic unit until they audibly click into Position the pre-assembled water barrier flange on place (see Figs.: 12 and 13).
Single-line building package ESH Basic FUBO SR1 BHP ► Positioned and stable basic unit installed vertically, a- Plastic tapping screw ligned with the batter board and filled with sand (see Seal insert Fig.: 19). • The upper finished floor edge always has to be 11 Installing the seal insert above the basic unit flange.
Single-line building package ESH Basic FUBO SR1 BHP 12 Installing the extension set If the basic unit is concreted in too deeply or the floor construction is higher than 225 mm, it is possible to extend the basic unit as required by mounting additi- onal compensation frames (see Fig.: 31).
Need help?
Do you have a question about the ESH Basic FUBO SR1 BHP and is the answer not in the manual?
Questions and answers