Digital Watchdog MEGApix Ai DWC-XSBE05Li User Manual page 40

Set up - Network Set up
SMTP Settings
1
2
3
4
5
6
7
8
9
10
An SMTP needs to be set up to send/save the image to the relevant sites by e-mail.
General Setting - Enable or disable the SMTP function.
1
Mode - Select the security mode of SMTP from Plain or SSL/TLS. After checking the account setup of your
2
SMTP Server, you may select one.
SMTP Server Address - Define the SMTP Server Address. If the IP Address form is incorrect, a message box will
3
be shown to try again.
Port - Define the Port used in the Plain or SSL/TLS security mode above.
4
User ID - Define the User ID to access the SMTP Server. Fill out the correct User ID registered in the SMTP Server.
5
Password - Define the Password to access the SMTP Server. Fill out the correct Password registered in the
6
SMTP Server.
E-Mail Sender - Define the e-mail address of the e-mail Sender. It will be displayed as the sender when the
7
camera sends an e-mail.
E-Mail Receiver - Define the e-mail address of the e-mail Receiver. It will be displayed as the Receiver when the
8
camera sends an e-mail.
Title - Define the title of the e-mail when the camera sends an e-mail.
9
The title of the e-mail is limited to 40 characters, including the spaces.
Message - Define the contents of the e-mail when the camera sends an e-mail. The message of the email is
10
limited to 40 characters, including the spaces.
Click 'TEST' to send a test message 'Apply' to save all settings.
11
40
11