Telebit T3000 Reference Manual page 91

&F2 Intelligent Answer Mode. Used with most
computers running intelligent software that
interprets the modem result codes and adjusts the
interface speed accordingly. Modem result codes
are sent to the computer. The modem interface
speed follows the connect speed.
&F3 System V (HDB) UUCP. Used with most
HoneyDanBer UUCP UNIX systems. (You must
have: /usr/lib/uucp/Systems, Devices, and Dialers
files).
For additional information when configuring the
modem for UUCP protocol support, use your
hardware and software configuration guides for
your UNIX operating system or refer to the
Nutshell handbook entitled Managing UUCP And
Usenet published by O'Reilly and Associates, Inc.
For specific configuration guides, call your
Technical Support representative, 408-734-5200.
&F4 Ver 2 (BSD) UUCP 4.2-4-3 and SCO Xenix. Used
with most Version 2 UUCP systems (You must
have: /usr/lib/uucp/L.sys and L-devices files).
For additional information when configuring the
modem for UUCP protocol support, use your
hardware and software configuration guides for
your UNIX operating system or refer to the
Nutshell handbook entitled Managing UUCP And
Usenet published by O'Reilly and Associates, Inc.
For specific configuration guides, call your
Technical Support representative, 408-734-5200.
5-16 AT Command Descriptions