Table 3-3. Configurations Set Only With An - Telebit T3000 Reference Manual

To select a prestored configuration from the front
panel, use the T/D and
A/B
switches. The LEDs
provide a visual display of the configuration selected.
Not all of the preset configurations are accessible
from the front panel. Refer to Table 3-3.
Table 3-3. Configurations Set Only With an AT&F Command
Prestored Configuration
AT&F
Command
Async/Sync Hayes &M1 &F32
HP3000 (host) &F33-
HP3000 (terminal) &F34
To load a prestored configuration into the T3000
modem, follow the steps below. Table 3-2 shows the
various LED displays encountered while selecting a
default set.
1. Determine which configuration you wish to set
as a default. To store the configuration as
Configuration A, set the A/B switch to position
A. To store the configuration as Configuration
B, set the A/B, switch to position B.
2. Enter the configuration select mode by holding
down the T/D switch while turning on the
power. Release the T/D switch when the MR,
OH, CD, HS, and EC LEDs flash.
3. View the configuration choices by pressing the
T/D switch for less than two seconds. The
LEDs change to the next choice each time you
press the switch (refer to Table 3-2).
3-6 The Basics