Telebit T3000 Reference Manual page 117

register, then it disconnects the call. This time-out
prevents hung connections from running up an
expensive connection cost. The register default
setting of 0 disables the inactivity timer.
S45 Remote Access Enable
Range: 0 or 255
Default: 0
See also: S180, S181
The S45 register enables or disables access to the
modem control functions from a remote modem.
To allow remote command access, the modems must
connect with MNP, and this register on both modems
must be set to 255 before connecting.
Remote access is not enabled for a session unless
these condition are met. Possible contents of this
register are as follows:
O Disables remote access.
255 Enables/negotiates remote access.
S46 Modem Security
Range: 0-3
Default: 0
See also: -U, -L, -N
Register S46 determines the type of call security used
when the modem answers an incoming call.
To change the setting of this register, you must enter
a password. The default system password is "PEP,"
which must be entered in upper case. You can change
the password by entering the -U command.
6-1 O AT Register Descriptions