Graco SDI15 Instructions Manual page 9

F . 11 CAL Flashing; Meter Ready for Calibration
IG
• Use the current calibration.
a. Press and hold RESET key to lock in the cur-
rent, unchanged, amount.
b. Display returns to the Dispense Mode.
OR . . .
• Recalibrate the Meter
NOTE:
MODEL 247453:
A one quart (US) or one liter (metric) Weights and Mea-
sures approved container is required for calibration.
This meter is factory calibrated to dispense 10W-30
motor oil at 70°F (21°C) at 2.0 gpm (7.6 lpm) and is
acceptably accurate for most common fluids over a typi-
cal temperature range. If you will use the meter to dis-
pense antifreeze or other approved fluids, you may have
to recalibrate it for greater accuracy.
a. If the unit of measurement is gallons, pints, or
quarts, dispense exactly one quart of fluid into a
calibrated 1–quart container.
If the unit of measurement is liters, dispense
exactly one liter of fluid into a calibrated 1–liter
container.
For proper calibration, you must dispense
the exact amount.
Continue calibration step b.
313048D
.
CAL
MODEL 24G738:
A one quart (US) or one liter (metric) Weights and Mea-
sures approved container is required for calibration.
This meter is factory calibrated to dispense water at
70°F (21°C) at 2.5 gpm (9.5 lpm).
a. If the unit of measurement is gallons, pints, or
quarts, dispense exactly one quart of water into
a calibrated 1–quart container.
If the unit of measurement is liters, dispense
exactly one liter of water into a calibrated 1–liter
container.
For proper calibration, you must dispense
the exact amount.
Continue calibration step b.
b. Hold down TOTAL key until display shows 1.00
(F . 12). The new calibration is complete.
IG
F . 12 Calibration Complete
IG
c. Press the RESET key to store the new calibra-
tion factor and return to the dispense mode.
NOTE:
If an error was made during meter recalibration, repeat
steps a - b of the recalibration procedure to recalibrate
the meter again.
Meter Setup and Operation
.
CAL
9