Graco SDI15 Instructions Manual page 8

Meter Setup and Operation
1. Press and hold both the TOTAL and RESET keys.
The All Segments screen and then the Software
Version screen shown in F
NOTE: The last two numeric digits of the number
displayed on the Software Version screen reflect the
version of software your meter is using.
In the illustration shown in F
sion is represented as "
OO
" " is replaced with a number which is the actual
software version used by your meter.
For example, if you are running software version 5,
the display will show:
All Segments Screen
; ; ;
Software Version
.
F . 7 Reset and Software Version Screens
IG
2. When the until R-TOTAL flashes (F
a. Press TOTAL again to clear the displayed reset-
table total and reset the Total to 0 . . . OR
F . 8 Programmed Unit of Measurement
IG
b. Continue with the meter setup by pressing the
RESET key to display the current measurement
unit (PTS, QTS, GAL, LITERS) programmed
8
. 7 display.
IG
. 7; the software ver-
IG
OO
". On your meter the
.
1.01.05
PTS QTS
GAL
LITERS
AUTO CAL R-TOTAL
.
. 8):
IG
R-TOTAL
into the meter (F
F . 9
IG
3. Press the TOTAL key to display the other available
measurement units.
NOTE:
Each time you press the Total key a different mea-
surement unit flashes on the screen (F
F . 10 Unit of Measurement Flashes
IG
4. When the desired unit of measurement displays,
push the RESET key to select it.
5. CAL flashes on the display as shown in F
one of the following:
. 9).
IG
. 10).
IG
. 11. Do
IG
313048D