Graco SDI15 Instructions Manual page 6

Meter Setup and Operation
Meter Setup and Operation
Setup
Terms
The following terms are shown on the display and/or
used often in this instruction manual.
• R-TOTAL: Resettable Total
Shows the cumulative amount that has been dis-
pensed. Can be reset to zero.
• TOTAL: Non–Resettable Total
Shows the cumulative amount that has been dis-
pensed for the life of the unit. Cannot be reset.
• Dispense Mode
Dispense mode in which display counts up from
zero or from where it recently stopped.
• ASLEEP / AWAKE Mode
Asleep is a battery–saving mode in which the dis-
play goes blank after 45 seconds of inactivity. The
display comes Awake from sleep mode when you
press any key on the keypad or fluid starts to flow.
Activation Mode
There are two ways to activate display:
• Press any key on the keypad to wake up the digital
display. The amount displayed is the value stored
when the meter went into sleep mode.
• Dispense fluid through the meter to wake up the dig-
ital display. Dispensing fluid through the meter
causes the meter to count up from the last displayed
value (F . 2).
IG
F . 2 Example of Total for Last Dispense Cycle
IG
6
Keypad Keys (F
F . 3 Keypad
IG
TOTAL
In Dispense mode press the Total key once to display
the Resettable Total. Pressing the Total key again dis-
plays the Non–resettable Total.
During meter setup, Total is used to reset the Resetta-
ble Total, scroll through available measurement units
(see Changing Measurement Units, page 7) and sets
the new calibration factor (See Recalibrating the Meter,
page 9).
R-TOTAL: Resettable Total
The Resettable Total (displayed when R-TOTAL is on
the screen as shown in F
amount dispensed since the last time the total was
reset.
GAL
F . 4 R-TOTAL
IG
To display the Resettable Total, push and hold the
TOTAL key for a few seconds until R-TOTAL displays
on the screen as shown in F
. 3)
IG
,
R-TOTAL
TOTAL RESET
. 4) is a running total of the
IG
. 4.
IG
R-TOTAL
313048D