Graco SDI15 Instructions Manual page 7

The amount displayed can be reset to zero at any time
from the setup menus.
Non-resettable Total
The Non-resettable Total (displayed when TOTAL is
on the screen as shown in F
amount that has been dispensed by the meter over the
life of the meter.
The meter continues to increase the amount displayed,
up to 99,999.99 gallons (or liters) dispensed, before
returning to zero. The user cannot reset this amount.
F . 5 Example of Accumulated Total
IG
To display the Non-resettable Total push and hold the
TOTAL key. The meter displays the R-TOTAL screen
(F . 4) first. Continue to hold the Total key until TOTAL
IG
displays on the screen as shown in F
The non-resettable total is shown in gallons when the
unit of measurement is set in gallons, quarts, or pints.
The non-resettable total is shown in liters when the
measurement is in liters.
RESET*
In Dispense mode, press and hold the RESET key to
clear the digital display after each dispense cycle.
Always press the RESET key to clear the digital display
before each new dispense.
During meter setup the RESET key is used to display
the resettable totals and to display and set the units of
measurement (See Changing Measurement Units, page
8) and for setting a new calibration factor when recali-
brating the meter (See Recalibrating the Meter, page 9).
For Maximum Dispense Accuracy
Set the meter to dispense in pints or quarts when dis-
pensing 1 gallon (3.8 liters) or less.
313048D
. 5) is the accumulated
IG
TOTAL
. 5.
IG
Displaying Setup Menus
* Press and hold Reset and
Total keys simultaneously to
display meter setup menus.
Changing Measurement Units
F . 6 shows the various measurement units (Liter,
IG
pints, quarts and gallons) as they appear on the display.
F . 6 Examples of Measurement Units
IG
Meter Setup and Operation
,
R-TOTAL
TOTAL RESET
,
.
.
.
7