Table of Contents
Advertisement
3. Make sure that the power cord is unplugged.
Locate the Upright Wire (90) attached to the
Base (96) with a tie. Remove the tie.
Next, identify the Right Upright (92). Have a
second person hold the Right Upright near the
Base (96).
See the inset drawing. Locate the wire tie (C)
in the Right Upright (92). Tie the wire tie through
the wire pull (D) on the Upright Wire (90). Next,
feed the Upright Wire into the Right Upright, and
pull the upper end of the wire tie until the Upright
Wire is routed through the Right Upright. Do not
remove the wire tie yet.
4. Hold the Right Upright (92) against the Base
(96). Do not pinch the Upright Wire (90).
Attach the Right Upright (92) with three
3/8" x 3/4" Screws (1) and three 3/8" Star
Washers (9) as shown; do not fully tighten the
Screws yet.
Next, attach a Wheel (93) with a 3/8" x 1 3/4"
Screw (4); do not fully tighten the Screw yet.
Attach the Left Upright (not shown) and the
other Wheel (not shown) in the same way.
Note: There is not a wire on the left side.
3
C
92
90
96
4
1
9
4
93
9
C
D
90
92
C
64
90
96
9
92
1
Advertisement
Table of Contents
